Forum › General Discussion › General Help and Support v
Would this rotary encoder work with a glass-scale board?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Would this rotary encoder work with a glass-scale board?
MidniteMachinist Offline
Junior Member
**
Posts: 44
Threads: 18
Joined: Aug 2017
Reputation: 1
#5
07-15-2020, 01:50 AM
50k on both sets it is, then. This is for an existing setup... So no special orders necessary. Just adding a rotary table readout for the W axis on my mill.

Thanks again for the help.
YouTube: FnA-Wright Engineering
Find
Reply


Messages In This Thread
RE: Would this rotary encoder work with a glass-scale board? - by MidniteMachinist - 07-15-2020, 01:50 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)