Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Part Layout
#1
First off amazing job on this.   

I work with a lot of high school students teaching them how to mill and make robot parts for a competition called FIRST robotics.  One of are biggest problems is getting kids to read the prints correctly so i had an ideas for you that would be really cool

1)Be able to upload a CAD drawing so that you could see where your tool is and where it should go.  Basically what you have for hole but with a whole part
2) It would be nice to save the drawing so you could use them again some time
Reply


Messages In This Thread
Part Layout - by bpk9p4 - 11-03-2016, 06:40 PM
RE: Part Layout - by Yuriy - 11-04-2016, 02:12 AM
RE: Part Layout - by bpk9p4 - 11-04-2016, 01:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)