The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.3.27 (Linux)
File Line Function
/showthread.php 864 errorHandler->error




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tool library editing
#1
I've got several tools saved in the TouchDRO app on my lathe. If I need to edit one of them, the edit function doesn't work correctly. The values I enter are either not saved, saved as all zeroes, saved with the decimal point 5 or more places off, or saved with some number that's wildly different from what I entered. So far, my method to combat this has been to just delete the tool and add it anew, but then it's not the same tool number.

So...If I edit, say, tool #2, the offset values get all wonky. So I delete it, and re-add it with the proper offsets. But now it's at the bottom of the tool list, with whatever number is next after the last tool. So if I want the tool labeled "#2" to be in the #2 slot, I've got to delete every single tool on the list, and re-add them in order. This isn't a big deal with 2-3 tools, but I've got more than a dozen tool holders, all with different offsets. It's a real pain to have to re-add them all every single time I extend/retract a boring bar to suit a job.
Reply


Messages In This Thread
Tool library editing - by MidniteMachinist - 05-01-2020, 03:21 AM
RE: Tool library editing - by Yuriy - 05-01-2020, 04:54 AM
RE: Tool library editing - by MidniteMachinist - 05-01-2020, 05:09 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)