Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DIY DRO Kit USB connectors
#1
New arrival here so please forgive me if this problem has been resolved elsewhere. I have tried searching but I can’t see anything obvious.

I’ve recently purchased a DIY DRO Adapter kit and am eagerly awaiting it’s arrival so I can get TouchDRO up & running on my mini mill. In the meantime, I’ve been trying to source some female Micro-B breakout boards to go with the kit and connect my iGaging Digimag Remote scales (purchased from arceurotrade in the UK), but I’m not having much success.

The problem lies with the fact that Yuriy’s board has only four points to connect the female USB’s required for X,Y & Z, identified (according to Yuriy’s documentation) as:

+3.3v
clock
data
GND

whilst the only breakout boards I can find here in the UK have five connections identified as:

VCC
D-
D+
ID
GND

Can anyone point me in the direction of a source for the right connectors please or tell me how to get five into 4?

Many thanks .


Iain
Reply


Messages In This Thread
DIY DRO Kit USB connectors - by Iain - 04-29-2020, 01:22 PM
RE: DIY DRO Kit USB connectors - by ejv5f - 04-29-2020, 04:39 PM
RE: DIY DRO Kit USB connectors - by Iain - 04-29-2020, 06:27 PM
RE: DIY DRO Kit USB connectors - by Yuriy - 04-30-2020, 12:19 AM
RE: DIY DRO Kit USB connectors - by Iain - 04-30-2020, 10:34 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)