Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MSP430 I/O Port failure?
#4
Hi Yuriy,

Thanks for your response and knowledge.
I am located in the Netherlands.. So far away from you I assume.
It could be an error in the launchpad PCB with a bridge , however since this a launchpad board from TI, I would expect it passed their QA testing ... Smile
I did built it into an enclosure and am using the DRO now for my lathe.
I will get it out and check carefully the PCB board .

Thanks,
Frans
Reply


Messages In This Thread
MSP430 I/O Port failure? - by FransTrein - 03-23-2020, 03:30 PM
RE: MSP430 I/O Port failure? - by FransTrein - 04-22-2020, 08:46 AM
RE: MSP430 I/O Port failure? - by Yuriy - 04-30-2020, 12:25 AM
RE: MSP430 I/O Port failure? - by FransTrein - 04-30-2020, 10:14 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)