Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
0.5uM scales do work!
#4
Installed my z axis, and my nexus7 was locked up and had to reinstall After reinstall I had to set cpi to 25400 to work correct when it was working correct at 50800, I dont know what happened I tested it on my phone and it too  set to 25400 , which indicates that my scales are 1.0 micron and not 0.5. Anyway on the Z axis I can get missed steps if I crank the hand wheel at 160 rpm (91"/min ) my carriage moves .57" per rev. Cranking at 120rpm (2 revs/sec) it does not skip. I can live with that
Reply


Messages In This Thread
0.5uM scales do work! - by sparkness - 10-16-2019, 03:01 PM
RE: 0.5uM scales do work! - by Yuriy - 10-17-2019, 03:36 AM
RE: 0.5uM scales do work! - by sparkness - 10-18-2019, 02:52 AM
RE: 0.5uM scales do work! - by sparkness - 10-21-2019, 11:33 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)