Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
X and Z axis's not working
#1
Hi there, just received my Touch DRO for glass scales board, powered up , connecting to blue tooth, testing the axis's and X and Z are not working- one digit flickers when i move the encoder. works fine for the Y and W axis. put the board under the microscope and I see nothing out of place. the encoder is TTL output , just testing on the bench, have clean power in, getting 5.00 V out on the encoder pins and 3.27 on the 3.3v rail, am I doing something wrong?
Reply


Messages In This Thread
X and Z axis's not working - by sparkness - 10-09-2019, 06:39 PM
RE: X and Z axis's not working - by sparkness - 10-09-2019, 09:16 PM
RE: X and Z axis's not working - by Briney Eye - 10-09-2019, 09:36 PM
RE: X and Z axis's not working - by sparkness - 10-09-2019, 10:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)