Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dropping reading/value on Z axis
#1
My Z axis won't hold its reading and will reset or pick a random value during an operation. 

I have an AccuRemote scale hooked up to all three axis and the X and Y have had no problems.

I didn't know if this was a scale issue and in writing this realize I could swap scales on the board and see if this still happens. Regardless I wasn't sure if anyone else had this issue and could provides some help.

Here's a link to my setup:
https://forum.yuriystoys.com/showthread.php?tid=278

Thank in advance and thanks again to Yuriy for putting all this together!!! 

_Mike
Reply


Messages In This Thread
Dropping reading/value on Z axis - by Mtracz - 05-01-2019, 12:41 PM
RE: Dropping reading/value on Z axis - by Mtracz - 05-02-2019, 11:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)