Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connected/Not Connected
#3
(10-03-2018, 10:46 AM)kommando Wrote: I have a completely different Tablet that does the same with my 4 axis fully built board and 2 axis DIY board setups, a tablet reboot solves it but it can be annoying.

Good to know that I'm not the only one.  I did a little research into it, and the next time it happens I'm going to try a "Force Stop" on the app, which would be less annoying than rebooting the tablet.
Reply


Messages In This Thread
Connected/Not Connected - by Briney Eye - 09-27-2018, 05:38 AM
RE: Connected/Not Connected - by kommando - 10-03-2018, 10:46 AM
RE: Connected/Not Connected - by Briney Eye - 10-03-2018, 03:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)