Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need Help!
#3
Sad I have just started  by purchasing a new assembled board.
 I got as far as calibrating the X axis of my mill. When I tried calibrating the  Y axis I repeatedly get a message that the scale is not connected. I even replaced the scale with a new one. Still no go. The scales both work with the original scale readers.
How do I get to the bottom of this.
Reply


Messages In This Thread
Need Help! - by lsidave - 08-18-2018, 06:03 PM
RE: Need Help! - by Yuriy - 08-18-2018, 06:19 PM
RE: Need Help! - by Alfred - 01-04-2023, 01:50 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)