Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gear calculator
#1
Would it be possible to implement a gear cutting function, using the W axis with a rotary table? Enter the blank diameter and the number of desired teeth, and have the DRO give the rotational positiion of each tooth? As in: Cut a tooth, hit a "Next" button, crank the rotary table to "0" on the readout, make the cut, an so on?
Reply


Messages In This Thread
Gear calculator - by MidniteMachinist - 07-29-2018, 03:29 AM
RE: Gear calculator - by HarriPort - 11-09-2018, 07:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)