Forum › General Discussion › General Help and Support v
Touch probe?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Touch probe?
MidniteMachinist Offline
Member
***
Posts: 63
Threads: 27
Joined: Aug 2017
Reputation: 1
#1
06-01-2018, 03:51 AM
I've got an iGaging board, and am trying to figure out the touch probe input. How exactly would I wire one to the board? I'm looking to make a normally-open probe, and cannot figure out which of the 3 solder pads to use. I have figured out that the square pad is +3.3v.

Further, where is the "touch" displayed on the tablet readout?

Thanks for any/all help.
YouTube: FnA-Wright Engineering
Find
Reply


Messages In This Thread
Touch probe? - by MidniteMachinist - 06-01-2018, 03:51 AM
RE: Touch probe? - by MidniteMachinist - 06-04-2018, 08:00 AM
RE: Touch probe? - by bobdring - 06-05-2018, 07:05 PM
RE: Touch probe? - by MidniteMachinist - 06-07-2018, 02:49 AM
RE: Touch probe? - by bobdring - 06-07-2018, 05:39 AM
RE: Touch probe? - by MidniteMachinist - 06-07-2018, 05:54 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)