SOLVED: Basic controller reads Igaging scale, but Universal does not

[Steve]

[quote='Yuriy' pid='1207' dateline='1527522758']


Thank you Yuriy.

So that would mean (for X channel Digimag ) and using "Mixed" firmware and voltage converter board, remove the board jumper that goes to P2.0, and reconnect it to p1.7?

No, you need both. The controller still needs to get clock and data in. It uses the pulses on the clock line to read the data line state. Digimag scales get their clock from the display, not the reading head, so they won't push any data. P1.7 is for the scale, but the MCU will still get it through P2.0.

Thank you
Yuriy

WOOHOO! It works!

Thank you Yuriy.