Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
USB pinout needed
#1
Question 
I have a set of AccuRemote scales and a iGaging adapter the problem is (1) I don't know much about electronics and (2) when I cut and stripped the micro USB cables the color of the wires do not match any code I have been able to find. I have (pin 1) Red, (pin 2) White, (pin 3) Blue, (pin 4) Brown, and (pin 5) Black. That's about where my knowledge of this stuff ends. I can make a couple of assumptions, and I hope someone will correct me if I'm wrong, but I think (pin 1) Red goes to VCC and (pin 5) Black goes to ground on the adapter. That said I cannot find anything that says what the other pins should go to on the adapter. The pinouts I have seen say pin 2 is Data-, pin 3 is Data+ and pin 4 is ID so which ones go to Data and clock on the adapter? 

[Image: rect4763.png]

Btw, Since there doesn't appear to be a standard for what color wire does what in a USB cable I'm hoping this will lead to a chart that other users can benefit from.
Reply


Messages In This Thread
USB pinout needed - by Dan in OR - 08-25-2016, 04:55 PM
RE: USB pinout needed - by Yuriy - 08-25-2016, 05:31 PM
RE: USB pinout needed - by Dan in OR - 08-25-2016, 06:15 PM
RE: USB pinout needed - by Dan in OR - 08-26-2016, 01:36 AM
RE: USB pinout needed - by Yuriy - 09-07-2016, 04:04 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)