Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help identifying encoder outputs
#1
Photo 
Hi all,

I am trying to set up a DRO for a lathe and mill using a PCB level incremental encoder sensor RLC2HD like this: Renishaw encoder

I have purchased two TouchDro's for magnetic scales, now looking at the pin functions, these are marked  as 5V; A; B; Gnd; A'; B'    the output on the RLC2HD encoders is: 5v; 5v; Gnd; NC; NC; Z; B; A. Refer to attached diagram.

What output signal should I use? I was reasoning I have to use one 5v output, the Gnd, and the A and B outputs, but what about the Z and the other 5v outputs?

Thanks in advance for any advice offered!

Regards Chris


Attached Files Thumbnail(s)
   
Reply


Messages In This Thread
Help identifying encoder outputs - by chrisB - 04-16-2018, 05:51 PM
RE: Help identifying encoder outputs - by chrisB - 04-17-2018, 01:19 PM
RE: Help identifying encoder outputs - by Romeo - 06-30-2018, 09:07 AM
RE: Help identifying encoder outputs - by Romeo - 07-02-2018, 12:06 PM
RE: Help identifying encoder outputs - by chrisB - 12-14-2019, 07:42 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)