Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Asimeto Indicators
#1
I bought the mixed DRO kit, without looking at the indicators I intended to use for a special project (not actually a DRO on a machine tool, but instead using it as a remote display).  It turns out that the indicators that I planned to interface (Asimeto) don't use a standard Chinese SPC connector, but instead use a mini USB connector.  Actually I like the use of the USB vs the normally found connector but the lack of information on them is a problem.

Has anyone used these before?  I am assuming the USB connector uses the standard pinout, but am unsure what protocol.

https://www.travers.com/0-1-digital-indi...7-031-131/

Thanks!
Reply


Messages In This Thread
Asimeto Indicators - by fiteboss - 02-24-2018, 08:02 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)