Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Quadrature Adapter Board
#5
(12-15-2017, 02:49 AM)Yuriy Wrote:
(12-14-2017, 01:39 PM)leew Wrote: I'm trying to use the M-DRO 5 micron magnetic encoders with the board.  I've tried plugging into the X, Y, & Z ports.  If I plug the scales into any of these ports the touch light comes on and no movement is detected, so I'm sure that I have not connected them correctly.  Attached is a schematic of how I have connected them and a scan of the pin outs from the technical information sheet available online and the installation guide that was sent to me with the scales.  Any help would be greatly appreciated.

The connection looks reasonable. Are you getting any output from the board to the tablet?

I can connect via bluetooth but I don't get any output to the tablet.
Reply


Messages In This Thread
Quadrature Adapter Board - by leew - 12-09-2017, 10:58 PM
RE: Quadrature Adapter Board - by Yuriy - 12-09-2017, 11:16 PM
RE: Quadrature Adapter Board - by leew - 12-14-2017, 01:39 PM
RE: Quadrature Adapter Board - by Yuriy - 12-15-2017, 02:49 AM
RE: Quadrature Adapter Board - by leew - 12-15-2017, 03:22 AM
RE: Quadrature Adapter Board - by Yuriy - 12-15-2017, 04:03 AM
RE: Quadrature Adapter Board - by leew - 12-15-2017, 04:52 PM
RE: Quadrature Adapter Board - by Yuriy - 12-17-2017, 05:44 PM
RE: Quadrature Adapter Board - by leew - 12-17-2017, 09:00 PM
RE: Quadrature Adapter Board - by Yuriy - 12-19-2017, 01:17 AM
RE: Quadrature Adapter Board - by leew - 12-19-2017, 11:14 PM
RE: Quadrature Adapter Board - by Yuriy - 12-20-2017, 01:34 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)