Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cable length - place of the controller
#1
Hi,
I've got two questions :
- must I shorten the cables coming from the scales ?
- where do you recommend to place the TouchDRO controller : on the mill, far from the motor / speed controller of the mill, away from vibrations ?
Regards
Thierry
Reply


Messages In This Thread
Cable length - place of the controller - by ThLDQ - 10-18-2017, 04:42 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)