Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A hello and pre-order questions (I'm ready)
#1
Hi y'all. Been snooping here and reading up for some time now in prep to outfit my Grizzly G0768 lathe with DRO.

First, thank you Yuri for your work on this. I'm a huge proponent of openSource and DIY. I don't want to spend more on a DRO system than my lathe is worth Smile

So I'm going with iGaging scales. I'm debating between the aluminum and Stainless. I thought I saw a post where Yuri said once mounted, is no appreciable difference in accuracy? I don't mind spending the extra for stainless if it buys me stability, noise reduction, or any other positive.

I'm going to get the the board with Micro B's and either the aluminum or stainless from Amazon depending on feedback here.

Tablet -- going to go to Costco and see what's available cheap and big Smile

thanks guys and HI Smile

Jim
Dallas, Tx
Reply


Messages In This Thread
A hello and pre-order questions (I'm ready) - by jhinze - 08-21-2017, 06:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)