Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mixed Scale Kit BT Module
#1
I tried to post a comment under the "How to Build the Mixed Scale Digital Readout Kit" but couldn't seem to get it to take.

The text of that comment is as follows:

Yuri, re the Bluetooth Module.

Is there any reason I couldn't bend the leads at right angles as you did, but bend them the other way such that the BT module sits *under* the PCB (with some gap)?

This would have the advantage of staying within the PCB profile at a small cost in height. If the PCB were mounted on stand-offs, the BT module could sit in the gap.

Perhaps it could be answered here?
Reply


Messages In This Thread
Mixed Scale Kit BT Module - by dnaman - 08-08-2017, 09:50 PM
RE: Mixed Scale Kit BT Module - by Yuriy - 08-09-2017, 12:30 AM
RE: Mixed Scale Kit BT Module - by dnaman - 08-09-2017, 12:40 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)