Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Absolute DRO+
#1
Hi, have a couple questions about using the Absolute DRO+ scales with a MSP430 Launchpad. 

There are several posts spread out over a long period of time and I have been trying to piece them together.

It looks like they are only supported on the "Mixed" scale firmware is that correct? Not the Igauging specific version.


Also looking at the pre-built boards there aren't external pull up resistors present, but in the "connecting Absolute DRO+ scales" post it shows the need for an adapter board to connect to the MSP430. Are the internal pull ups not enabled for the MSP430 DIY firmware? I guess the root of my question is are the external pull ups still required on the current versions? 

Thanks!
Reply


Messages In This Thread
Absolute DRO+ - by Trilitheum - 07-08-2017, 01:42 PM
RE: Absolute DRO+ - by Dale McBride - 07-08-2017, 09:45 PM
RE: Absolute DRO+ - by Trilitheum - 07-09-2017, 12:05 AM
RE: Absolute DRO+ - by Yuriy - 07-09-2017, 01:26 AM
RE: Absolute DRO+ - by Trilitheum - 07-09-2017, 01:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)