Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hall Effect Sensor Module
#2
It MAY work with the controller, it depends on if the resistor is wired in as a pull-up resistor on the signal line.
The datasheet isn't very clear about that.
If it is, the power source would have to be from the 3.3V rail or you will fry the controller
Alternatively, the signal will have to go thru a voltage divider or level shifter circuit first.

Find a module with a powered output such as one of these:

https://www.sainsmart.com/sainsmart-hall...oCiUTw_wcB

With the powered type, you connect the DO pin to the controller tach input and power it from the board. The same signal level caveat applies to these modules, too.
Regards,
Brian
Reply


Messages In This Thread
Hall Effect Sensor Module - by Kiwi - 05-31-2017, 09:55 AM
RE: Hall Effect Sensor Module - by Eskimo2k - 05-31-2017, 11:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)