Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Parallel (dual DRO) operation possible?
#1
My question is:

I already have a Sino 3-Axis DRO installed on my mill.  The scales are glass scales.  Is it possible to add the TouchDRO system to my existing system without loosing the functionality of the original DRO?  Or in other words, can I take the output of my scales and rout the signal to both the original DRO as well as this sytem and add the MUCH BETTER interface?  Thanks for your feedback on the noob question.
Reply


Messages In This Thread
Parallel (dual DRO) operation possible? - by supwicha - 05-09-2017, 05:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)