Smithy Granite 3in1

[mhafele]

I just installed scales on all three axis of my Smithy Granite 1324 3in1 mill/lathe combo that I've only had a few weeks.   With the TouchDRO app I set up two preferences one for the machine as a mill and one for the machine as a lathe.   I ran into an issue where using machine as a mill the x axis is typically the direction of travel of the carriage and the  y is perpendicular to that (this is also how they describe it in the machine manual).   That's all good until I use it as a lathe and set a preference as a lathe and  the diameter/radius function is applied to the x not the y.   Easy fix to just swap cables but now  have to reprogram my brain to remember what is x and what is y.   Is there a way in lathe mod to set what axis the dia/rad function applies too?

FYI,  love this DRO.   I did have to put capacitors in the scale heads to prevent jumping any time I turned on the mill/shopvac/air compressor in my shop.  Once installed never saw a jump.  

Thanks,
Matt