Hi everybody.
I've received and soldered my Launchpad to the USB breakboards.
The launchpad came with two chips : one MSP430G2553, and one MSP430G2452.
Which one should I use ? I would bet on the 2553...
It is written in the notice that the chip is already loaded with one or more programs. Do I have to delete them before loading the TouchDRO program?
There is also a micro quartz in the box. What do I do with it ?
Last question : what about the jumpers on the board : P1.6, P1.8, VCC, TEST, RST, RXD, TXD ?
Regards
Thierry
I've received and soldered my Launchpad to the USB breakboards.
The launchpad came with two chips : one MSP430G2553, and one MSP430G2452.
Which one should I use ? I would bet on the 2553...
It is written in the notice that the chip is already loaded with one or more programs. Do I have to delete them before loading the TouchDRO program?
There is also a micro quartz in the box. What do I do with it ?
Last question : what about the jumpers on the board : P1.6, P1.8, VCC, TEST, RST, RXD, TXD ?
Regards
Thierry