Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Solved : Serial to USB adapter
#9
You guessed right with the chip, the G2553 is the one you want.
The micro quartz is a watch crystal oscillator that can be soldered onto the Launchpad as an external clock source. You do NOT use it for this project. Also, it solders onto the same pins that the W axis uses.
When you Flash the firmware onto the chip, the old program will automatically be deleted.
Leave the jumpers the way you found them (i.e all jumpers connecting the emulation side to the MSP430G2 side), it will not affect the controller, and if you plan to power it from the USB plug, the Vcc jumper must be left in that configuration.

Whew, did I miss anything?
Regards,
Brian
Reply


Messages In This Thread
Solved : Serial to USB adapter - by ThLDQ - 03-02-2017, 08:00 PM
RE: Serial toUSB adapter - by Yuriy - 03-02-2017, 08:21 PM
RE: Serial toUSB adapter - by ThLDQ - 03-03-2017, 09:09 AM
RE: Serial toUSB adapter - by Yuriy - 03-03-2017, 03:34 PM
RE: Serial toUSB adapter - by ThLDQ - 03-03-2017, 04:54 PM
RE: Serial toUSB adapter - by Eskimo2k - 03-07-2017, 04:49 PM
RE: Serial toUSB adapter - by ThLDQ - 03-07-2017, 05:00 PM
RE: Serial toUSB adapter - by ThLDQ - 03-14-2017, 04:20 PM
RE: Serial toUSB adapter - by Eskimo2k - 03-17-2017, 12:29 PM
RE: Serial toUSB adapter - by ThLDQ - 03-17-2017, 01:35 PM
RE: Serial toUSB adapter - by Yuriy - 03-20-2017, 04:56 PM
RE: Serial toUSB adapter - by Eskimo2k - 03-18-2017, 02:45 PM
RE: Serial toUSB adapter - by ThLDQ - 03-20-2017, 05:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)