Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Solved : Serial to USB adapter
#8
Hi everybody.
I've received and soldered my Launchpad to the breakboards.
It came with two chips : one MSP430G2553, and one MSP430G2452.
Which one should I use ? I would bet on the 2553...
It is written in the notice that the chip is already loaded with one or more programs. Do I have to delete them before loading TouchDRO ?
There is also a micro quartz in the box. What do I do with it ?
Last question : what about the jumpers on the board : P1.6, P1.8, VCC, TEST, RST, RXD, TXD ?
Regards
Thierry
Reply


Messages In This Thread
Solved : Serial to USB adapter - by ThLDQ - 03-02-2017, 08:00 PM
RE: Serial toUSB adapter - by Yuriy - 03-02-2017, 08:21 PM
RE: Serial toUSB adapter - by ThLDQ - 03-03-2017, 09:09 AM
RE: Serial toUSB adapter - by Yuriy - 03-03-2017, 03:34 PM
RE: Serial toUSB adapter - by ThLDQ - 03-03-2017, 04:54 PM
RE: Serial toUSB adapter - by Eskimo2k - 03-07-2017, 04:49 PM
RE: Serial toUSB adapter - by ThLDQ - 03-07-2017, 05:00 PM
RE: Serial toUSB adapter - by ThLDQ - 03-14-2017, 04:20 PM
RE: Serial toUSB adapter - by Eskimo2k - 03-17-2017, 12:29 PM
RE: Serial toUSB adapter - by ThLDQ - 03-17-2017, 01:35 PM
RE: Serial toUSB adapter - by Yuriy - 03-20-2017, 04:56 PM
RE: Serial toUSB adapter - by Eskimo2k - 03-18-2017, 02:45 PM
RE: Serial toUSB adapter - by ThLDQ - 03-20-2017, 05:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)