Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Not getting a reading
#1
Hi, I have a problem with one axis on my milling machine. The y axis is not showing a reading. I am using capacitive scales. If I swap the the scales around I still cannot get a reading on the y. Is there something I need to do. This is my 2nd touchdro unit, the first one I had to send back as it was defective. 
I now see that this model of touchdro is no longer available in the shop. Is there a problem with these units, or I hope have I overlooked something. I have noticed that the y axis button is outlined in green. Does this mean something? The working axis do not have the button outlined
Reply


Messages In This Thread
Not getting a reading - by Terry1956 - 03-10-2024, 10:11 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)