Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lathe X-axis incorrect reading
#3
(01-30-2024, 12:32 AM)MidniteMachinist Wrote: Sounds like you calibrated in Diameter mode.

I just went out, switched to radius, and recalibrated.  Yes, it's now correct.

I'm very surprised to see that setting affect calibration, *as well* as not having it called out in the calibration dialog.

Thanks!
Reply


Messages In This Thread
Lathe X-axis incorrect reading - by flux - 01-29-2024, 11:53 PM
RE: Lathe X-axis incorrect reading - by flux - 01-30-2024, 04:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)