Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
touch probe for edge finding
#1
Hi All,
Thank you for letting me onboard! I have installed my touch DRO on a CX601 mill and think its a good gadget with my limited amount of use so far.
I am wondering about adding a electronic touch probe as an edge finder and see it identified on the board. 

  1. What specifications should I be looking for when shopping for a probe to connect to these 3 pins? 
  2. Is there a common model that has been used with good success?
  3. Is there a video somewhere that will help with the connecting of the probe to the board and then the setup of it?
Sorry if the answers to these questions are obvious, I'm fairly new to the mill and the electronics of the DRO.

Thank you
Reply


Messages In This Thread
touch probe for edge finding - by theflyingwrench - 01-08-2024, 08:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)