Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Android app upgrade using diy v1.1
#1
Yuri
Very long time no post. I last posted 2.5 years ago. I have a version 1.1 board built from a kit you provided years ago. About 2 years ago Inretired your system  (to a CNC on my mill) but have just reactivated for my lathe.. My initial connection to my lathe was amazingly easy. Then it seems that android updated the app to the latest version and since then things have become very unstable, often (mostly) with the app not reading the gauge. The android device sees HC05 and I can select it in the app settings but then the signal drops all the time from the gauge. I have tested the gauge with the readout and it is fine. Any ideas?
Reply


Messages In This Thread
Android app upgrade using diy v1.1 - by Aussieatlarge - 11-25-2023, 11:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)