Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Y axis stopped working
#4
(11-12-2021, 02:18 PM)drinkr Wrote: I’m not sure if this is the version but the board has 2.4 written in pen on it. Also when I opened it I saw the y micro connector has broken free. I had the wires and box mounted permanently so I didn’t expect that.

That's the "old" MSP430 based board. I had a batch of those with "cold" solder joints and a few made it into the wild before I caught the problem. Yours is likely #8 of that batch.
Please email me (yuriy at touchdro dot com).
Reply


Messages In This Thread
Y axis stopped working - by drinkr - 11-11-2021, 11:00 PM
RE: Y axis stopped working - by Yuriy - 11-12-2021, 01:09 AM
RE: Y axis stopped working - by drinkr - 11-12-2021, 02:18 PM
RE: Y axis stopped working - by ejv5f - 11-12-2021, 06:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)