![]() |
MSP430 + Glass Scales, need help with voltage divider - Printable Version +- Forum (https://forum.yuriystoys.com) +-- Forum: General Discussion (https://forum.yuriystoys.com/forumdisplay.php?fid=5) +--- Forum: DIY Controller Builds, etc. (https://forum.yuriystoys.com/forumdisplay.php?fid=10) +--- Thread: MSP430 + Glass Scales, need help with voltage divider (/showthread.php?tid=630) |
MSP430 + Glass Scales, need help with voltage divider - robgeorge - 09-14-2020 Hi all, Trying to get an MSP430 working with Glass scales, but cannot figure out the wiring of the 2 resistor voltage divider. I am using Ditron scales with a Dsub 9 connector, The pinouts is the same as what is posted on the site. I am hoping for an actual photo as it is hard me to to understand the diagrams on the site. Just really need a photo of how 1 axis is setup as I will be able to figure out how to wire the additional axis's This is the page I have been looking at. https://www.yuriystoys.com/2014/01/connecting-glass-dro-scales-to.html Also I assume I don't need any additional power supplies, just the usb phone charger which will power the MSP430 and the glass scales? I previously built the igaging diy msp430 by following the detailed photos but I can no longer use it as I ended up with an incompatible Chinese scale. Thank you |