+- Forum (https://forum.yuriystoys.com)
+-- Forum: General Discussion (https://forum.yuriystoys.com/forumdisplay.php?fid=5)
+--- Forum: General Help and Support (https://forum.yuriystoys.com/forumdisplay.php?fid=3)
+--- Thread: Dropping reading/value on Z axis (/showthread.php?tid=437)
Dropping reading/value on Z axis - Mtracz - 05-01-2019
My Z axis won't hold its reading and will reset or pick a random value during an operation.
I have an AccuRemote scale hooked up to all three axis and the X and Y have had no problems.
I didn't know if this was a scale issue and in writing this realize I could swap scales on the board and see if this still happens. Regardless I wasn't sure if anyone else had this issue and could provides some help.
Here's a link to my setup:
https://forum.yuriystoys.com/showthread.php?tid=278
Thank in advance and thanks again to Yuriy for putting all this together!!!
_Mike
RE: Dropping reading/value on Z axis - Mtracz - 05-02-2019
One note to add, the setup worked for a good while and started this about 4 months ago.
_Mike