Dead X axis input - Printable Version

+- Forum (
+-- Forum: General Discussion (
+--- Forum: General Help and Support (
+--- Thread: Dead X axis input (/showthread.php?tid=411)

Dead X axis input - Jay Pregent - 01-15-2019

I have the "No Solder Kit" and have just finished the install.

When I built the enclosure I tested it with just moving a scale by hand and everything was fine.

Now that I have everything connected I get no response from the X axis input.  The scale is fine. it works when I connect it to an other input.  Also I swapped the header connectors to see if the problem was in there.

Every part works in every combination as long as it is not connected to the X axis input.

Is there a setting that I am not checking or do I have a problem?  I am scratching my head.