+- Forum (https://forum.yuriystoys.com)
+-- Forum: General Discussion (https://forum.yuriystoys.com/forumdisplay.php?fid=5)
+--- Forum: General Help and Support (https://forum.yuriystoys.com/forumdisplay.php?fid=3)
+--- Thread: Problems with W (/showthread.php?tid=335)
Problems with W - Ralphxyz - 04-16-2018
I am finally calibrating My TouchDRO on my Clausing 8520 vertical mill.
I have X Y and Z calibrated but having problems with W.
I am using the 1" side of my 123 bar.
I zero out and go down to the table and get 306.56 (note no ") for 1" of travel.
If I zero on the table and go up to the test block I get 355.92 (again no ") for 1" of travel.
Help!!
I have no idea what is going on.
It keeps jumping to incr even when I select abs for all of the scales.
Ralph
RE: Problems with W - Briney Eye - 04-16-2018
Those numbers sound suspiciously like angles. Check the setup.
RE: Problems with W - Ralphxyz - 04-16-2018
(04-16-2018, 06:06 PM)Briney Eye Wrote: Those numbers sound suspiciously like angles. Check the setup.
Sorry, how do I check the setup?
I do not see any settings.
Ralph
RE: Problems with W - Ralphxyz - 04-17-2018
duh, I was using Mode Display (Angular) anyone have any idea what Display (Angular) means or what one could do with it.
Was there ever a consolidated documentation package, that would really help with a lot of my ignorant questions.
So I switched to Add to Z readout, and now I am able to get calibration numbers.
But having a hard time getting calibrated, I have tried so much that now I can no longer Connect bluetooth and get the message "DRO has died" or "DRO stopped working".
I might have to do a reinstall of TouchDro.
Well I was making progress.
Ralph