Forum
Asimeto Indicators - Printable Version

+- Forum (https://forum.yuriystoys.com)
+-- Forum: General Discussion (https://forum.yuriystoys.com/forumdisplay.php?fid=5)
+--- Forum: DIY Controller Builds, etc. (https://forum.yuriystoys.com/forumdisplay.php?fid=10)
+--- Thread: Asimeto Indicators (/showthread.php?tid=312)



Asimeto Indicators - fiteboss - 02-24-2018

I bought the mixed DRO kit, without looking at the indicators I intended to use for a special project (not actually a DRO on a machine tool, but instead using it as a remote display).  It turns out that the indicators that I planned to interface (Asimeto) don't use a standard Chinese SPC connector, but instead use a mini USB connector.  Actually I like the use of the USB vs the normally found connector but the lack of information on them is a problem.

Has anyone used these before?  I am assuming the USB connector uses the standard pinout, but am unsure what protocol.

https://www.travers.com/0-1-digital-indicator-with-analog-display/p/57-031-131/

Thanks!