+- Forum (https://forum.yuriystoys.com)
+-- Forum: General Discussion (https://forum.yuriystoys.com/forumdisplay.php?fid=5)
+--- Forum: Feature Requests (https://forum.yuriystoys.com/forumdisplay.php?fid=7)
+--- Thread: Inside/outside probing (/showthread.php?tid=1070)
Inside/outside probing - MidniteMachinist - 10-01-2023
Would it be possible to be able to set inside/outside measurements for each probe point?
I was machining a step feature, and needed to drill a hole in the center of the step. I tried to pick up the front of the step (outside measurement), then the back of the step (inside measurement)... But when I tapped the inside/outside button, it switched all the coordinates to "outside".
This has the effect of placing the DRO center exactly one probe-tip-diameter forward (towards the front of the part) of the ACTUAL center.