Forum
Y axis stopped working - Printable Version

+- Forum (https://forum.yuriystoys.com)
+-- Forum: General Discussion (https://forum.yuriystoys.com/forumdisplay.php?fid=5)
+--- Forum: General Help and Support (https://forum.yuriystoys.com/forumdisplay.php?fid=3)
+--- Thread: Y axis stopped working (/showthread.php?tid=1017)



Y axis stopped working - drinkr - 11-11-2021

I have been working with my repaired touch dro with no problem since it was repaired a while ago. Tonight the y axis stopped working. I swapped the x and y and the igage for the y axis works fine in the x slot. What should be my next step to fix this?


RE: Y axis stopped working - Yuriy - 11-12-2021

(11-11-2021, 11:00 PM)drinkr Wrote: I have been working with my repaired touch dro with no problem since it was repaired a while ago. Tonight the y axis stopped working. I swapped the x and y and the igage for the y axis works fine in the x slot. What should be my next step to fix this?

Which version of the board do you have?


RE: Y axis stopped working - drinkr - 11-12-2021

I’m not sure if this is the version but the board has 2.4 written in pen on it. Also when I opened it I saw the y micro connector has broken free. I had the wires and box mounted permanently so I didn’t expect that.


RE: Y axis stopped working - ejv5f - 11-12-2021

(11-12-2021, 02:18 PM)drinkr Wrote: I’m not sure if this is the version but the board has 2.4 written in pen on it. Also when I opened it I saw the y micro connector has broken free. I had the wires and box mounted permanently so I didn’t expect that.

That's the "old" MSP430 based board. I had a batch of those with "cold" solder joints and a few made it into the wild before I caught the problem. Yours is likely #8 of that batch.
Please email me (yuriy at touchdro dot com).