Forum

Full Version: Dropping reading/value on Z axis
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
My Z axis won't hold its reading and will reset or pick a random value during an operation. 

I have an AccuRemote scale hooked up to all three axis and the X and Y have had no problems.

I didn't know if this was a scale issue and in writing this realize I could swap scales on the board and see if this still happens. Regardless I wasn't sure if anyone else had this issue and could provides some help.

Here's a link to my setup:
https://forum.yuriystoys.com/showthread.php?tid=278

Thank in advance and thanks again to Yuriy for putting all this together!!! 

_Mike
One note to add, the setup worked for a good while and started this about 4 months ago. 

_Mike