Forum

Full Version: Save machine profiles?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Good morning, I looked on the forum but haven't found it yet. 

Can I possibly save machine "profiles" from one tablet to move to another tablet?

Thank you so much for your time and help-
Dave
Is it that this can't be done and that's why no-one chimed in?
I do not think that can be done. I'm assuming you mean the CPI and that type info. I used two different tablets and just entered the info in both, I do not switch between tablets during a job though. And yes it does seem.at times there are few responses to posts here I think it would be nice if more people posted that have experience.
(08-09-2018, 03:01 AM)Tweinke Wrote: [ -> ]I do not think that can be done. I'm assuming you mean the CPI and that type info. I used two different tablets and just entered the info in both, I do not switch between tablets during a job though. And yes it does seem.at times there are few responses to posts here I think it would be nice if more people posted that have experience.

Thanks so much as I appreciate your input. I was actually referring to saving a "Mill" profile from one tablet to load onto another tablet so I didn't have to re-setup the new tablet scale factors (just being lazy...lol). 

Thanks again!
Dave-
Work smarter not harder, I understand that!