Forum

Full Version: igaging board and rotary table encoder ?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hi, id like to build any kind of encoder to my rotary table to read the angle from there.

i use igaging scales and the bludro igaging touchdro board.

in my understanding the 4th axis (W) only supports another igaging like scale.

is ther any encoder/sensor/whatever that would speak the "21bit language" and is able to measure rotary angle ?
or would the firmware of the igaging touchdro even support rotary table anle on the 4th axis ?

greets and thanks notger