Forum

Full Version: DIY board build
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I am following this for my DIY board build

http://www.yuriystoys.com/2013/10/build-...ifter.html

The part list has optional capacitors

0.1 uF ceramic capacitor 3 Radio Shack

1000 uF or larger electrolytic capacitor*1Radio Shack

I can see where the 3 0.1 uF capacitors go on the voltage shifter board but cannot see where the 1000 uF one goes. I have a mill with 2 VFD's and 2 motors so planning to need all the interference help from the start.

Edit

Reading more I can see it goes on the 5v side and as I will be using glass scales then I do need it, but where ?


Quote:* This is needed only for the 5V rail; if you don’t plan to use this with glass scales, it can be skipped