Full Version: Can not set Zero (0)
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I attempted to use the hole pattern function and must have entered something wrong as the coordinates I was lead to were not correct.

I cleared all points and was going to try again, but now I can not 0 the Y axis.  It seems to be stuck on a value that I have no idea where it came from.

If I move the mill table then try to 0 it goes back to this value.

Any help would be appreciated.
I guess today just isn't my day.  I attempted to attach an image, but not luck.  Trying again.

Thanks, I'll wait for the update.