Now to preface I ended up using ditron magnetic scales for my x and y, those have worked great once I got all the EMI noise cleaned up from my VFD. My mill has a shahe z axis on my quill, and I was planning on making another mag scale for the z, but I wondered if maybe I could wire in the shahe scale since I don't really need the refresh rate or accuracy on my quill. Is this possible? I searched the forum but couldn't seem to find any other questions that answered this question. I may have missed it.
I have the same situation. I'm using the optical scales that came on my Bridgeport with a TouchDRO board for optical/magnetic scales. Would like to add a quill z-axis input.
(09-29-2022, 05:04 AM)Pyrex Wrote: [ -> ]Now to preface I ended up using ditron magnetic scales for my x and y, those have worked great once I got all the EMI noise cleaned up from my VFD. My mill has a shahe z axis on my quill, and I was planning on making another mag scale for the z, but I wondered if maybe I could wire in the shahe scale since I don't really need the refresh rate or accuracy on my quill. Is this possible? I searched the forum but couldn't seem to find any other questions that answered this question. I may have missed it.
So I've stumbled onto an answer to this question... unfortunately, after I purchased the TouchDRO board for Magnetic/Optical scales.
It turns out that the TouchDRO board for Shahe and iGaging scales also supports quadrature (magnetic/optical) input with some caveats (i.e. level translation required for iGaging board, not for Shahe board, and lower 10Hz refresh rate on both boards. The board for mag/opto scales updates at 25Hz).
More info here...
https://www.touchdro.com/resources/adapt...oders.html
There's a lot of info here on Yuri's site and on the TouchDRO purchase site spread over a very long period of time and it's tough to sift through it all. Good info, just challenging to dig through.
I didn't initially think about mixing scale types, so I didn't look at the other TouchDRO boards. After I got the optical scales that came on my mill hooked up, I thought it would be nice to tie in the quill readout, which tend to be the much more compact capacitive scales.